The card includes Xilinx’s ZYNQ 7000 series(XC7Z045-2FFG900I) consists PS system integrates two ARM CortexTM-A9 Processors.

 Board is equipped with 256Mbit Quad-SPI Flash chip which is used as Boot Device. 

A non-volatile QSPI flash of 256Mbit is attached to the Zynq SoC FPGA PL portion. This Flash is used for the user parameter and data storage. Configuration settings for the board are stored in this flash. 

The ADC31JB68 is designed to operate at low power and give very high SNR performance with a 4-Vpp full scale input. Using a low noise 16-bit front end stage followed by a 14-bit ADC, the device gives 85-dBFS SNR up to 10 MHz and better than 80-dBFS SNR up to 30 MHz. 

1Gbit Ethernet (PCS/PMA) to communicate with PC – CISO SFP-10GSR, UART (Debug Configuration).

Length: 160mm

Height:  100mm

Thickness (+/-5%) : 1.6mm

Operating Environmental Temperature: -45°c to +85°c 

Data Convertor 

16 Bit ADC’s (Single Channel):  4

Max Rate (MSPS):   500

Input Range: 4 Vpp

SNR: 85 -dBFS up to 10MHz 

          80 -dBFS up to 30MHz 

Configuration

JTAG      :      Yes

SPI         :      Yes

QSPI       :     Yes

UART      :    Yes 

Memory

DDR3                :    4Gb (256M x 16)

Quad-SPI Flash :   256Mb

SD Card Slot     :   Yes

Communication 

RJ45  :  1

Control & IO 

Programmable IO Lines:  50

Expansion Connectors 

VPX Connector:  1

Clocking 

Standard Clock Oscillator:  Yes

Programmable clock:  Yes

Power 

+5V Regulator   :   Yes

RESOURCES 

Featuring the  4 Channel Data Acquisition Card – Zynq 700 Soc(XC7Z045-2FFG900I)

Programmable Logic Cells:  350K 

Block RAM(36 Kb Blocks):  19.2 Mb (545)

DSP Slices:  900

Look-Up Tables (LUTs):  218,600

Maximum IO Pins:  PS IO’s – 128   &   PL IO’s – 362

Maximum Transceiver Count:  16

Free Resources

• Download Resource 1
• Download Resource 2
• Download Resource 2